This grit range is fairly common and you may already have some sandpaper that matches. In fact you may not get the spackling flush with the surface around it.įor sanding drywall or spackling patches, you want to stay with a grit between 100 - 150. If the sandpaper is too fine, you will work a lot harder to get the surface smooth. The scratches can show through the paint and mar the appearance of your wall.
Best spackle for drywall holes Patch#
If the grit is too coarse it will leave scratches on the spackling patch and the surface around it. You can use standard sandpaper to sand spackling, although there are some cautions. Sanding sponges are sold at the same place that you buy your paint and spackling. The other nice feature is that the sponge is formed into the shape of a block, so the surface of the sanding area stays flat. They come in a variety of sizes, with most of them fitting into the palm of your hand. They are made of synthetic material and have a grit formed into the surface. Sanding sponges are a convenient way to do light sanding especially on drwall and drywall products like spackling.
Best spackle for drywall holes how to#
Sand it flat with the wall surface around it.įor related information you want to see the articles on " How To Use Spackling', ' How To Repair Drywall' and ' Patching Drywall'. When the spackling paste is dry you can lightly sand it with a sanding sponge or sandpaper. Sanding does not take very long, usually only a couple of minutes. You should also sand lightly between coats. If it's a screw, use the appropriate screwdriver to push the screw back into the drywall.Sanding spackle needs to be done when the spackling compound has dried completely. If it's a nail, use a hammer to push the nail back into the drywall so that it's flush with the wall. You can use the putty knife to scratch off the surface area to expose the nail or screw. It's more like a paint-colored bump in your wall.įirst, you'll want to determine if it's a nail or a screw popping out. These are areas where, over time, either a nail or screw starts to jut out of the drywall, but isn't necessarily a hole. This process also works for old nail holes, or small cracks or openings in your drywall.ĭoes this look familiar? Follow these tips to make your wall look like new again. To ensure that the drywall spackle is completely covered and blends into the rest of the wall, you'll want to do at least two coats of paint. Wait a few hours for the paint to dry, then add another coat. Using a paint brush or a paint roller, cover the surface area evenly with one coat of paint. Now that the area is smoothed out, you can go over it with the paint. Once you've finished applying the spackle and it's dried, you can use the sandpaper to smooth out any bumps in the drywall before you paint over it.
You can repeat this as many times as necessary until you get a flush layer to the rest of the wall. If the drywall surface area still seems uneven, you can add another coat the same way - again, use the putty knife and spread the spackle over the area and let it dry for a few hours. Now, we wait.Īfter a few hours, inspect the spackled area. Again, the DAB DryDex spackle is great because it dries from pink to white, so it takes the guesswork out of the drying time. Next, you'll want to wait a few hours for the spackle to dry. You can always add another layer or two to get the surface area even.
Now to cover up the hole, apply the spackle with the putty knife and try to fill it in as evenly as possible.
0 kommentar(er)
